| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Vehicle Interior | Section: Theft Deterrent/Keyless Entry | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000002XWO00AX |
| Title: THEFT DETERRENT / KEYLESS ENTRY: ENTRY LOCK AND UNLOCK SWITCH (for Front): INSTALLATION (2008 LX570) | ||
INSTALLATION
HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.
1. INSTALL FRONT DOOR HANDLE ASSEMBLY OUTSIDE LH
|
(a) Install the handle by pushing it in the direction of the arrow in the illustration. |
|
(b) Using a T30 "TORX" socket, tighten the screw. |
(c) Connect the connector.
2. INSTALL FRONT DOOR OUTSIDE HANDLE COVER LH
3. INSTALL FRONT DOOR SERVICE HOLE COVER LH
4. INSTALL DOOR TRIM COVER LH
5. INSTALL FRONT DOOR PANEL CUSHION
6. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
7. INSTALL COURTESY LIGHT ASSEMBLY
8. INSTALL FRONT UPPER ARMREST BASE PANEL LH
9. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH
10. INSTALL FRONT LOWER DOOR FRAME BRACKET GARNISH LH
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
12. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light
.
13. INSTALL ENGINE ROOM SIDE COVER LH
|
|