1. REMOVE SHIFT LOCK RELEASE BUTTON COVER

2. REMOVE SWITCH WIRE

(a) Disconnect the 5 connectors, detach the 3 clamps and remove the wire from the position indicator housing.

3. REMOVE CONSOLE BOX POCKET

(a) Detach the integration control & panel connector.

(b) Remove the 2 screws and console box pocket from the position indicator housing.

4. REMOVE LOWER POSITION INDICATOR HOUSING

(a) Remove the 4 screws and lower position indicator housing from the position indicator housing.

5. REMOVE POSITION INDICATOR LENS

(a) Detach the 4 claws and remove the position indicator lens from the lower position indicator housing.

6. REMOVE POSITION INDICATOR SLIDE COVER

(a) Remove the position indicator slide cover together with the No. 2 position indicator slide cover.

(b) Remove the No. 2 position indicator slide cover from the position indicator slide cover.

7. REMOVE INDICATOR LIGHT WIRE SUB-ASSEMBLY

(a) Detach the indicator light wire connector.

(b) Using a small screwdriver, detach the claw and pull out the indicator light wire from the lower position indicator housing.

8. REMOVE SHIFT LOCK RELEASE BUTTON

(a) Detach the 2 claws and remove the shift lock release button and spring from the lower position indicator housing.

9. REMOVE INTEGRATION CONTROL & PANEL SUB-ASSEMBLY

(a) Remove the 5 screws, and then remove the integration control & panel from the position indicator housing.

10. REMOVE NO. 1 PATTERN SELECT SWITCH ASSEMBLY

(a) Using a small screwdriver, detach the 2 claws and remove the pattern select switch from the position indicator housing.

11. REMOVE SHIFT LOCK CONTROL ECU SUB-ASSEMBLY

(a) Disconnect the shift lock solenoid connector.

(b) Detach the 3 claws and remove the ECU from the transmission floor shift.