- An ECM main CPU error.
- An ECM sub CPU error.
| Last Modified: 11-27-2007 | 1.6 C | |
| Service Category: Engine/Hybrid System | Section: Engine Control | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000002Z1T00SX |
| Title: 3UR-FE ENGINE CONTROL: SFI SYSTEM: DESCRIPTION (2008 LX570) | ||
|
DTC |
P060E |
Internal Control Module Throttle Position Performance |
DESCRIPTION
The ECM monitors the input signals of the Throttle Position (TP) sensor No. 1 and stop light switch. As the ECM monitors the input signals of the TP sensor No. 1 and the STP signals of the stop light switch, if the input signals and control signals are deviated, a DTC is stored.
|
DTC Code |
DTC Detection Condition |
Trouble Area |
|---|---|---|
|
P060E |
When either condition below is met: |
ECM |
MONITOR STRATEGY
|
Related DTCs |
None |
|
Required sensors/Components (Main) |
ECM |
|
Required sensors/Components (Related) |
- |
|
Frequency of operation |
Once per driving cycle |
|
Duration |
1 second |
|
MIL operation |
Immediate |
|
Sequence of operation |
None |
TYPICAL ENABLING CONDITIONS
|
DMA communication error |
Not detected |
TYPICAL MALFUNCTION THRESHOLDS
|
When one of following conditions is met: |
Condition 1 or 2 |
|
1. Difference of main TP and sub TP |
0.3 V or higher |
|
2. Difference of main brake switch signal and sub brake switch signal |
Different |
INSPECTION PROCEDURE
PROCEDURE
|
1. |
CHECK DTC |
(a) Clear DTC
.
(b) Turn the engine switch off.
(c) Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
(d) Connect the cable to the negative (-) battery terminal.
(e) Turn the engine switch on (IG).
(f) Check DTC.
OK:
P060E is not output.
|
|
|