| Last Modified: 11-27-2007 | 1.6 N | |
| Service Category: Vehicle Exterior | Section: Door/Hatch | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000002ZNT005X |
| Title: DOOR / HATCH: HOOD SUPPORT: DISPOSAL (2008 LX570) | ||
DISPOSAL
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
1. DISPOSE OF HOOD SUPPORT ASSEMBLY
|
(a) Horizontally fix the hood support in a vise with the piston-rod pulled out. |
(b) Wear safety glasses. Gradually cut any area between A and B shown in the illustration using a metal saw and gradually release the gas.
Standard:
|
Area |
Specified Condition |
|---|---|
|
a |
150 mm (5.91 in.) |
|
b |
20 mm (0.787 in.) |
CAUTION:
As metal debris may be blown outward by the gas, you must:
- Wear protective glasses.
- Cover the area being cut.
NOTICE:
The gas inside the hood support is colorless, odorless and harmless. As there is a possibility that metal debris could scatter, cover the hood support with a piece of cloth or other material.
|
|