Home › Engine/Hybrid System › Emission Control › 3UR-FE EMISSION CONTROL: AIR INJECTION DRIVER
Last Modified: 11-27-2007 1.6 A
Service Category: Engine/Hybrid System Section: Emission Control
Model Year: 2008 Model: LX570 Doc ID: RM0000030JA00CX
Title: 3UR-FE EMISSION CONTROL: AIR INJECTION DRIVER: INSTALLATION (2008 LX570)

INSTALLATION

1. INSTALL AIR INJECTION CONTROL DRIVER ASSEMBLY

(a) Install the air injection control driver with the 3 bolts.

Torque: 8.0 N·m (82 kgf·cm, 71 in·lbf)


(b) Connect the 4 air injection control driver connectors.

(c) Connect the wire harness clamp.

(d) Connect the ground wire with the bolt.

Torque: 8.0 N·m (82 kgf·cm, 71 in·lbf)

2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION (2008 LX570) .

3. INSTALL ENGINE ROOM SIDE COVER LH EXTERIOR PANELS / TRIM: RADIATOR GRILLE: INSTALLATION (2008 LX570)+