3UR-FE EMISSION CONTROL: AIR INJECTION DRIVER: REMOVAL (2008 LX570)

Home › Engine/Hybrid System › Emission Control › 3UR-FE EMISSION CONTROL: AIR INJECTION DRIVER

Last Modified: 11-27-2007		1.6 A
Service Category: Engine/Hybrid System	Section: Emission Control
Model Year: 2008	Model: LX570	Doc ID: RM0000030JC00CX
Title: 3UR-FE EMISSION CONTROL: AIR INJECTION DRIVER: REMOVAL (2008 LX570)

REMOVAL

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected .
w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

3. REMOVE AIR INJECTION CONTROL DRIVER ASSEMBLY

(a) Remove the bolt and disconnect the ground wire.

(b) Disconnect the wire harness clamp.

(d) Remove the 3 bolts and air injection control driver.