Home › Engine/Hybrid System › Engine Control › 3UR-FE ENGINE CONTROL: POWER STEERING OIL PRESSURE SWITCH
Last Modified: 11-27-2007 1.6 G
Service Category: Engine/Hybrid System Section: Engine Control
Model Year: 2008 Model: LX570 Doc ID: RM0000031E1006X
Title: 3UR-FE ENGINE CONTROL: POWER STEERING OIL PRESSURE SWITCH: ON-VEHICLE INSPECTION (2008 LX570)

ON-VEHICLE INSPECTION

1. INSPECT POWER STEERING OIL PRESSURE SWITCH

(a) Check the oil pressure switch.

(1) Connect the Techstream to the DLC3.

(2) Turn the engine switch on (IG).

(3) Turn the Techstream main switch on.

(4) Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Power Steering pressure.

(5) Start the engine.

(6) Operate the steering wheel while idling, and read the value on the Techstream.

Standard:

Measurement Condition

Specified Condition

Power steering not operating

0 to 2 MPa (0 to 20 kgf/cm2, 0 to 290 psi)

Power steering operating

Values change from above value

If not as specified, check for DTCs 3UR-FE ENGINE CONTROL: SFI SYSTEM: DTC CHECK / CLEAR (2008 LX570) . If the power steering system inspection results are normal and a DTC is not output, replace the power steering oil pressure switch.

Inspect the power steering system POWER ASSIST SYSTEMS: POWER STEERING SYSTEM: ON-VEHICLE INSPECTION (2008 LX570) . If the power steering system inspection results are normal and a DTC is not output, replace the power steering oil pressure switch.