Home Audio/Visual/Telematics Park Assist/Monitoring INTUITIVE PARKING ASSIST SYSTEM
Last Modified: 11-27-2007 1.6 U
Service Category: Audio/Visual/Telematics Section: Park Assist/Monitoring
Model Year: 2008 Model: LX570 Doc ID: RM0000035MD002X
Title: PARK ASSIST / MONITORING: INTUITIVE PARKING ASSIST SYSTEM: DATA LIST / ACTIVE TEST (2008 LX570)

DATA LIST / ACTIVE TEST

1. DATA LIST

HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus:

Body Electrical / Intuitive P/A / Data List.

(e) According to the display on the Techstream, read the Data List.

Intuitive P/A

Tester Display

Measurement Item/Range

Normal Condition

Diagnostic Note

Main Switch

Clearance sonar main switch/OFF or ON

OFF: Clearance sonar main switch off

ON: Clearance sonar main switch on

-

Clearance Sonar ECU Type

Type of clearance warning ECU/Normal or Steer

Normal: Normal clearance sonar type

Steer: Steering sensing type

-

Rr Sensor Onset Range

Buzzer activation range (for rear sensors)/Narrow or Wide

Narrow: Buzzer activation range narrow

Wide: Buzzer activation range wide

-

Keep Sense Buzzer

Buzzer operation/Not Avail or Avail

Not Avail: Buzzer sounds continuously

Avail: Buzzer stops

When the distance between the vehicle and an obstacle does not change for more than 3 seconds.

Fr & Rr Buzzer Volume

Buzzer volume setting/L, M1, M2, M3 or H

L: Buzzer volume low

M1: Buzzer volume medium low

M2: Buzzer volume medium

M3: Buzzer volume medium high

H: Buzzer volume high

-

Sensor Condition N

Sensor operation/Not Avail or Avail

Not Avail: Sensor does not operate

Avail: Sensor operates

When the shift lever is in N.

Approach Display OFF

Display operation/Not Avail or Avail

Not Avail: Display does not display

Avail: Display displays

When moving away from a previously detected obstacle.

Display Mode

Display mode setting/All or Updisp

All: Display displays all sensors

Updisp: Display does not display

When the intuitive parking assist system is normal.

Reverse Range Front Sensor

Operation setting for vehicle front sensors (front center, front corner, front side)/F or F Stop

F: All front sensors operate

F Stop: All front sensors stop

When the shift lever is in R.

Non P/R Range Rear Sensor

Operation setting for vehicle rear sensors (rear center, rear corner)/R, Rcrn or R Stop

R: All rear sensors operate

Rcrn: Rear corner sensors operate

R Stop: All rear sensors stop

When the shift lever is not in P or R.

Fr Left Sensor

Front corner sensor LH information/Undetect, Close R, Mid G, Mid L G, Long G, Mid Y, Mid L Y, Long Y, Freeze, Open or Blink

Undetect: Not detected

Close R: Detected (Close-range) [Red]

Mid G: Detected (Medium-range) [Green]

Mid L G: Detected (Long-range) [Green]

Long G: Detected (Maximum long-range) [Green]

Mid Y: Detected (Medium-range) [Yellow]

Mid L Y: Detected (Long-range) [Yellow]

Long Y: Detected (Maximum long-range) [Yellow]

Freeze: Sensor frozen

Open: Open in sensor

Blink: All displays blinking

-

Fr Right Sensor

Front corner sensor RH information/Undetect, Close R, Mid G, Mid L G, Long G, Mid Y, Mid L Y, Long Y, Freeze, Open or Blink

Undetect: Not detected

Close R: Detected (Close-range) [Red]

Mid G: Detected (Medium-range) [Green]

Mid L G: Detected (Long-range) [Green]

Long G: Detected (Maximum long-range) [Green]

Mid Y: Detected (Medium-range) [Yellow]

Mid L Y: Detected (Long-range) [Yellow]

Long Y: Detected (Maximum long-range) [Yellow]

Freeze: Sensor frozen

Open: Open in sensor

Blink: All displays blinking

-

Rr Left Sensor

Rear corner sensor LH information/Undetect, Close R, Mid G, Mid L G, Long G, Mid Y, Mid L Y, Long Y, Freeze, Open or Blink

Undetect: Not detected

Close R: Detected (Close-range) [Red]

Mid G: Detected (Medium-range) [Green]

Mid L G: Detected (Long-range) [Green]

Long G: Detected (Maximum long-range) [Green]

Mid Y: Detected (Medium-range) [Yellow]

Mid L Y: Detected (Long-range) [Yellow]

Long Y: Detected (Maximum long-range) [Yellow]

Freeze: Sensor frozen

Open: Open in sensor

Blink: All displays blinking

-

Rr Left Center Sensor

Rear center sensor LH information/Undetect, Close R, Mid G, Mid L G, Long G, Mid Y, Mid L Y, Long Y, Freeze, Open or Blink

Undetect: Not detected

Close R: Detected (Close-range) [Red]

Mid G: Detected (Medium-range) [Green]

Mid L G: Detected (Long-range) [Green]

Long G: Detected (Maximum long-range) [Green]

Mid Y: Detected (Medium-range) [Yellow]

Mid L Y: Detected (Long-range) [Yellow]

Long Y: Detected (Maximum long-range) [Yellow]

Freeze: Sensor frozen

Open: Open in sensor

Blink: All displays blinking

-

Rr Right Center Sensor

Rear center sensor RH information/Undetect, Close R, Mid G, Mid L G, Long G, Mid Y, Mid L Y, Long Y, Freeze, Open or Blink

Undetect: Not detected

Close R: Detected (Close-range) [Red]

Mid G: Detected (Medium-range) [Green]

Mid L G: Detected (Long-range) [Green]

Long G: Detected (Maximum long-range) [Green]

Mid Y: Detected (Medium-range) [Yellow]

Mid L Y: Detected (Long-range) [Yellow]

Long Y: Detected (Maximum long-range) [Yellow]

Freeze: Sensor frozen

Open: Open in sensor

Blink: All displays blinking

-

Rr Right Sensor

Rear corner sensor RH information/Undetect, Close R, Mid G, Mid L G, Long G, Mid Y, Mid L Y, Long Y, Freeze, Open or Blink

Undetect: Not detected

Close R: Detected (Close-range) [Red]

Mid G: Detected (Medium-range) [Green]

Mid L G: Detected (Long-range) [Green]

Long G: Detected (Maximum long-range) [Green]

Mid Y: Detected (Medium-range) [Yellow]

Mid L Y: Detected (Long-range) [Yellow]

Long Y: Detected (Maximum long-range) [Yellow]

Freeze: Sensor frozen

Open: Open in sensor

Blink: All displays blinking

-

Parking Signal

Parking signal/OFF or ON

OFF: Shift lever not in P

ON: Shift lever in P

-

Reverse Signal

Reverse signal/OFF or ON

OFF: Shift lever not in R

ON: Shift lever in R

-

Vehicle Speed Info

Vehicle speed signal/SN STOP or SN WORK

SN STOP: Vehicle speed 13 km/h (8 mph) or more

SN WORK: Vehicle speed less than 9 km/h (5.6 mph)

-

Sonar Detection

Sonar detection condition/STOP or WORK

STOP: Sonar detection not operating

WORK: Sonar detection operating

-

Clearance Sonar ECU

ECU information/Abnormal or Normal

Abnormal: ECU not normal

Normal: ECU normal

-

Rr Right Freezed History

Rear corner sensor RH frozen history/Not Rec or Recorded

Not Rec: No record history

Recorded: Record history

-

Rr Right Center Freezed History

Rear center sensor RH frozen history/Not Rec or Recorded

Not Rec: No record history

Recorded: Record history

-

Rr Left Center Freezed History

Rear center sensor LH frozen history/Not Rec or Recorded

Not Rec: No record history

Recorded: Record history

-

Rr Left Freezed History

Rear corner sensor LH frozen history/Not Rec or Recorded

Not Rec: No record history

Recorded: Record history

-

Fr Right Freezed History

Front corner sensor RH frozen history/Not Rec or Recorded

Not Rec: No record history

Recorded: Record history

-

Fr Left Freezed History

Front corner sensor LH frozen history/Not Rec or Recorded

Not Rec: No record history

Recorded: Record history

-

# Codes

Number of stored trouble codes/min.: 0, max.: 255

Number of DTCs will be displayed

-

2. ACTIVE TEST

HINT:

Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus:

Body Electrical / Intuitive P/A / Active Test.

(e) According to the display on the Techstream, perform the Active Test.

Intuitive P/A

Tester Display

Test Part

Control Range

Diagnostic Note

Buzzer

NO. 1 clearance warning buzzer

Operate or Stop

-