Home › Vehicle Exterior › Exterior Panels/Trim › FRONT DOOR WINDOW FRAME MOULDING
Last Modified: 11-27-2007 1.6 A
Service Category: Vehicle Exterior Section: Exterior Panels/Trim
Model Year: 2008 Model: LX570 Doc ID: RM0000038LM002X
Title: EXTERIOR PANELS / TRIM: FRONT DOOR WINDOW FRAME MOULDING: INSTALLATION (2008 LX570)

INSTALLATION

HINT:

  • Use the same procedures for the RH side and LH side.
  • The procedures listed below are for the LH side.
  • When installing the window frame moulding, heat the vehicle body and window frame moulding using a heat light.

Standard:

Item

Temperature

Vehicle Body

40 to 60°C (104 to 140°F)

Window Frame Moulding

20 to 30°C (68 to 86°F)

NOTICE:

Do not heat the vehicle body and window frame moulding excessively.

1. INSTALL FRONT DOOR REAR WINDOW FRAME MOULDING LH

(a) Clean the vehicle body surface.

(1) Using a heat light, heat the vehicle body surface.

(2) Remove the double-sided tape from the vehicle body surface.

(3) Wipe off any tape adhesive residue with cleaner.

(b) Install a new window frame moulding.

(1) Using a heat light, heat a new window frame moulding and the vehicle body surface.

(2) Remove the peeling paper from the face of the window frame moulding.

HINT:

After removing the peeling paper, keep the exposed adhesive free from foreign matter.

(3) Attach the clip and double-sided tape to install the window frame moulding.

HINT:

Press the window frame moulding firmly to install it.

2. INSTALL FRONT DOOR BELT MOULDING ASSEMBLY LH EXTERIOR PANELS / TRIM: FRONT DOOR BELT MOULDING: INSTALLATION (2008 LX570)+

3. INSTALL FRONT DOOR GLASS RUN LH DOOR / HATCH: FRONT DOOR: REASSEMBLY (2008 LX570)+

4. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH DOOR / HATCH: FRONT DOOR: REASSEMBLY (2008 LX570)+

5. INSTALL FRONT INNER DOOR GLASS WEATHERSTRIP LH DOOR / HATCH: FRONT DOOR: REASSEMBLY (2008 LX570)+

6. INSTALL FRONT DOOR SERVICE HOLE COVER LH DOOR / HATCH: FRONT DOOR: REASSEMBLY (2008 LX570)+

7. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH MIRROR (EXT): OUTER REAR VIEW MIRROR: INSTALLATION (2008 LX570)+

8. INSTALL DOOR TRIM COVER LH DOOR / HATCH: FRONT DOOR: REASSEMBLY (2008 LX570)+

9. INSTALL FRONT DOOR PANEL CUSHION DOOR / HATCH: FRONT DOOR: REASSEMBLY (2008 LX570)+

10. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH DOOR / HATCH: FRONT DOOR: REASSEMBLY (2008 LX570)+

11. INSTALL FRONT UPPER ARMREST BASE PANEL LH DOOR / HATCH: FRONT DOOR: REASSEMBLY (2008 LX570)+

12. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH DOOR / HATCH: FRONT DOOR: REASSEMBLY (2008 LX570)+

13. INSTALL FRONT LOWER DOOR FRAME BRACKET GARNISH LH DOOR / HATCH: FRONT DOOR: REASSEMBLY (2008 LX570)+

14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION (2008 LX570) .

15. INSTALL ENGINE ROOM SIDE COVER LH EXTERIOR PANELS / TRIM: RADIATOR GRILLE: INSTALLATION (2008 LX570)+