SUPPLEMENTAL RESTRAINT SYSTEMS: REAR FLOOR AIRBAG SENSOR: REMOVAL (2008 LX570)

Home › Vehicle Interior › Supplemental Restraint Systems › REAR FLOOR AIRBAG SENSOR

Last Modified: 11-27-2007		1.6 A
Service Category: Vehicle Interior	Section: Supplemental Restraint Systems
Model Year: 2008	Model: LX570	Doc ID: RM0000038MW002X
Title: SUPPLEMENTAL RESTRAINT SYSTEMS: REAR FLOOR AIRBAG SENSOR: REMOVAL (2008 LX570)

REMOVAL

1. REMOVE ENGINE ROOM SIDE COVER LH

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

w/ Navigation System:

After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

When disconnecting the cable, some systems need to be initialized after the cable is reconnected .

3. REMOVE REAR STEP COVER

4. REMOVE REAR DOOR SCUFF PLATE LH

5. REMOVE REAR DOOR SCUFF PLATE RH

6. REMOVE REAR FLOOR AIRBAG SENSOR

(a) Fold back the floor carpet.

(b) Detach the clip and claw, and remove the cover.

(d) Disconnect the connector.