| Last Modified: 11-27-2007 | 1.6 G | |
| Service Category: Vehicle Interior | Section: Supplemental Restraint Systems | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM0000038MX002X |
| Title: SUPPLEMENTAL RESTRAINT SYSTEMS: REAR FLOOR AIRBAG SENSOR: ON-VEHICLE INSPECTION (2008 LX570) | ||
ON-VEHICLE INSPECTION
1. CHECK REAR FLOOR AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION)
(a) Perform a diagnostic system check
.
2. CHECK REAR FLOOR AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)
(a) Perform a diagnostic system check
.
(b) When airbags have deployed as the result of a collision, be certain to replace the rear floor airbag sensor when it is in the damaged area (anywhere in need of repair). Furthermore, it is also necessary to replace the rear floor airbag sensor in an undamaged area that has registered a major collision, or which exhibits any of the following abnormalities:
- Cracks, dents or chips on the sensor housing.
- Cracks or other damage to the connector.
- Peeling off of the label or damage to the serial number.
CAUTION:
For removal and installation procedures of the rear floor airbag sensor, be sure to follow the correct procedure.
3. CHECK REAR FLOOR AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG IS DEPLOYED)
(a) When airbags have deployed as the result of a collision, be certain to replace the rear floor airbag sensor in the damaged area (anywhere in need of repair). Furthermore, it is also necessary to replace the rear floor airbag sensor in an undamaged area that has registered a major collision, or which exhibits any of the following abnormalities:
- Cracks, dents or chips on the sensor housing.
- Cracks or other damage to the connector.
- Peeling off of the label or damage to the serial number.
CAUTION:
For removal and installation procedures of the rear floor airbag sensor, be sure to follow the correct procedure.
|
|