| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Vehicle Interior | Section: Seat | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000003953003X |
| Title: SEAT: FRONT SEATBACK HEATER: REMOVAL (2008 LX570) | ||
REMOVAL
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.
1. REMOVE ENGINE ROOM SIDE COVER LH
2. REMOVE FRONT SEAT ASSEMBLY LH
(a) Remove the front seat assembly
.
3. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
4. REMOVE RECLINING POWER SEAT SWITCH KNOB
5. REMOVE FRONT SEAT CUSHION SHIELD LH
6. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH
7. REMOVE FRONT INNER SEAT CUSHION SHIELD LH
8. REMOVE FRONT SEATBACK BOARD SUB-ASSEMBLY LH
9. REMOVE FRONT SEAT HEADREST SUPPORT
10. REMOVE SEATBACK COVER WITH PAD
|
(a) w/o Climate Control Seat System: Disconnect the seat heater connector and detach the 2 wire harness clamps. |
(b) w/ Climate Control Seat System:
|
(1) Disconnect the seat heater connector and detach the 3 wire harness clamps. |
|
(2) Detach the 2 claws and disconnect the duct. |
|
(c) Remove the 3 hog rings and detach the 9 hooks. |
|
(d) Remove the nut and seatback cover bracket from the seat frame. |
(e) Remove the seatback cover with pad.
11. REMOVE FRONT SEPARATE TYPE SEATBACK COVER
12. REMOVE FRONT SEATBACK HEATER ASSEMBLY LH
|
(a) Cut off the tack pins which fasten the seatback heater to the seatback cover, and then remove the seatback heater from the seatback cover. |
|
|