| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Vehicle Interior | Section: Seat Belt | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM0000039EJ004X |
| Title: SEAT BELT: REAR NO. 1 SEAT INNER BELT ASSEMBLY (for LH Side): REMOVAL (2008 LX570) | ||
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
-
w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
2. REMOVE REAR NO. 1 SEAT ASSEMBLY LH
(a) Remove the rear No. 1 seat assembly
.
3. REMOVE SEAT ADJUSTER BOLT COVER
4. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH
5. REMOVE REAR NO. 1 SEAT RECLINING COVER LH
6. REMOVE REAR NO. 1 SEAT RECLINING COVER RH
7. REMOVE UPPER SEAT TRACK RAIL COVER LH
8. REMOVE UPPER SEAT TRACK RAIL COVER RH
9. REMOVE REAR NO. 2 SEAT LEG SIDE COVER
10. REMOVE REAR NO. 2 SEAT PROTECTOR
11. REMOVE REAR NO. 1 SEAT HINGE SUB-ASSEMBLY LH
12. REMOVE REAR NO. 1 SEAT HINGE SUB-ASSEMBLY RH
13. REMOVE SEAT BELT ANCHOR COVER CAP
14. REMOVE REAR SEATBACK STAY COVER LH
15. REMOVE REAR UNDER SIDE COVER LH
16. REMOVE REAR SEAT CUSHION COVER RH
17. REMOVE REAR SEAT UNDER TRAY COVER LH
18. REMOVE REAR NO. 1 SEAT INNER BELT ASSEMBLY LH
(a) Remove the bolt and belt.
HINT:
The No. 1 seat 3 point type belt anchor is fixed with the same bolt as the rear No. 1 seat inner belt LH. Therefore, it becomes disconnected when the bolt is removed.
19. DISCONNECT NO. 1 SEAT 3 POINT TYPE BELT ASSEMBLY LH
(a) Disconnect the belt anchor.
|
|