| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Suspension | Section: Suspension Control System | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM0000039ZF001X |
| Title: SUSPENSION CONTROL: ACTIVE HEIGHT CONTROL PUMP AND MOTOR: DISASSEMBLY (2008 LX570) | ||
DISASSEMBLY
1. REMOVE HEIGHT CONTROL HOSE ASSEMBLY
|
(a) Disconnect the clamp from the reservoir, then remove the 2 clips and hose. |
2. REMOVE HEIGHT CONTROL CAP TO RESERVOIR HOSE
|
(a) Remove the 3 clips, 2 breather plugs and hose from the reservoir hose. |
|
(b) Pull the connector down to detach it and remove the hose from the reservoir tank. |
3. DISCONNECT NO. 4 FRAME WIRE
|
(a) Disconnect the 2 connectors, clamp and frame wire. |
4. REMOVE HEIGHT CONTROL COMPRESSOR BRACKET ASSEMBLY
|
(a) Remove the 3 nuts and bracket from the pump and motor. |
5. REMOVE HEIGHT CONTROL RESERVOIR ASSEMBLY
|
(a) Using a 5 mm hexagon wrench, remove the 5 bolts and reservoir from the pump and motor. |
6. REMOVE NO. 1 HEIGHT CONTROL BOLT CUSHION
(a) Remove the 3 bolt holders and 3 bolt cushions from the pump and motor.
|
|