| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Suspension | Section: Suspension Control System | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM0000039ZG001X |
| Title: SUSPENSION CONTROL: ACTIVE HEIGHT CONTROL PUMP AND MOTOR: REASSEMBLY (2008 LX570) | ||
REASSEMBLY
1. INSTALL NO. 1 HEIGHT CONTROL BOLT CUSHION
(a) Install the 3 bolt cushions and 3 bolt holders to the pump and motor.
2. INSTALL HEIGHT CONTROL RESERVOIR ASSEMBLY
|
(a) Using a 5 mm hexagon wrench, install the reservoir with the 5 bolts. Torque: 5.6 N·m (57 kgf·cm, 50 in·lbf) |
3. INSTALL HEIGHT CONTROL COMPRESSOR BRACKET ASSEMBLY
|
(a) Install the bracket with the 3 nuts. Torque: 5.5 N·m (56 kgf·cm, 49 in·lbf) |
4. CONNECT NO. 4 FRAME WIRE
|
(a) Connect the 2 connectors, clamp and frame wire. |
5. INSTALL HEIGHT CONTROL CAP TO RESERVOIR HOSE
|
(a) Install the hose to the reservoir tank, and push the connector up to attach it. |
|
(b) Install the hose, 2 breather plugs and 3 clips to the reservoir hose. |
6. INSTALL HEIGHT CONTROL HOSE ASSEMBLY
|
(a) Install the hose to the reservoir and motor with the 2 clips. |
(b) Connect the clamp to the reservoir.
|
(c) Check that the direction of the hose clip is as shown in the illustration. |
|
|