| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Suspension | Section: Suspension Control System | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000003BJ6001X |
| Title: SUSPENSION CONTROL: HEIGHT CONTROL SENSOR (for Rear Side): INSTALLATION (2008 LX570) | ||
INSTALLATION
1. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH
|
(a) Install the sensor with the 2 bolts and nut. Torque: 13 N·m (127 kgf·cm, 9 ft·lbf) Torque: 5.6 N·m (57 kgf·cm, 50 in·lbf) |
(b) Connect the connector and 2 clamps.
2. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH
|
(a) Install the sensor with the 2 bolts and nut. Torque: 13 N·m (127 kgf·cm, 9 ft·lbf) Torque: 5.6 N·m (57 kgf·cm, 50 in·lbf) |
(b) Connect the connector and 2 clamps.
3. INSTALL REAR WHEEL
Torque: 131 N·m (1336 kgf·cm, 97 ft·lbf)
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
5. PERFORM VEHICLE HEIGHT OFFSET CALIBRATION
(a) Perform the vehicle height offset calibration
.
6. ADJUST REAR HEIGHT SENSOR LINK SUB-ASSEMBLY
7. PERFORM ZERO POINT CALIBRATION OF G SENSOR
(a) Perform the zero point calibration of the G sensor
.
8. ADJUST HEADLIGHT ASSEMBLY
(a) Adjust the headlight
.
|
|