SEAT BELT: REAR CENTER SEAT OUTER BELT ASSEMBLY (for Rear No. 2 Seat): INSPECTION (2008 LX570)

Home › Vehicle Interior › Seat Belt › REAR CENTER SEAT OUTER BELT ASSEMBLY (for Rear No. 2 Seat)

Last Modified: 11-27-2007		1.6 G
Service Category: Vehicle Interior	Section: Seat Belt
Model Year: 2008	Model: LX570	Doc ID: RM000003BVM002X
Title: SEAT BELT: REAR CENTER SEAT OUTER BELT ASSEMBLY (for Rear No. 2 Seat): INSPECTION (2008 LX570)

INSPECTION

1. INSPECT REAR NO. 2 SEAT BELT ASSEMBLY 3 POINT TYPE

NOTICE:

Do not disassemble the retractor.

(a) When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks.

If the operation is not as specified, replace the belt.

(b) Check the fastening function of the child restraint system.

NOTICE:

The check should be performed with the outer belt installed.

(1) When the belt is pulled out fully, the belt should automatically start to retract.

(2) After the belt has fully retracted, the belt should be able to be pulled out and retracted again. If the operation is not as specified, replace the belt assembly.