| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Suspension | Section: Rear Suspension | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000003BZ8003X |
| Title: REAR SUSPENSION: REAR COIL SPRING: INSTALLATION (2008 LX570) | ||
INSTALLATION
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
-
A bolt without a torque specification is shown in the standard bolt chart
.
1. INSTALL HOLLOW SPRING SUB-ASSEMBLY
(a) Install the hollow spring to the frame.
2. INSTALL REAR COIL SPRING LH
|
(a) Install the coil spring. HINT:
Before installing the coil spring, check that the coil spring end is in the correct position. If not, reinstall it. |
3. TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY LH
|
(a) Temporarily install the lower side of the shock absorber with the bolt. |
4. TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY RH
|
(a) Temporarily install the lower side of the shock absorber with the bolt. |
5. TEMPORARILY INSTALL REAR LATERAL CONTROL ROD ASSEMBLY
6. CONNECT REAR FLEXIBLE HOSE
7. STABILIZE SUSPENSION
8. TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH
(a) Tighten the bolt.
Torque: 98 N·m (999 kgf·cm, 72 ft·lbf)
NOTICE:
Perform this procedure with all 4 wheels on the ground.
9. TIGHTEN REAR SHOCK ABSORBER ASSEMBLY RH
(a) Tighten the bolt.
Torque: 98 N·m (999 kgf·cm, 72 ft·lbf)
NOTICE:
Perform this procedure with all 4 wheels on the ground.
10. TIGHTEN REAR LATERAL CONTROL ROD ASSEMBLY
11. INSTALL REAR STABILIZER END BRACKET LH
|
(a) Connect the stabilizer end bracket with the 2 bolts. Torque: 36 N·m (367 kgf·cm, 27 ft·lbf) |
12. INSTALL REAR STABILIZER END BRACKET RH
(a) Connect the stabilizer end bracket with the 2 bolts.
Torque: 36 N·m (367 kgf·cm, 27 ft·lbf)
13. CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
14. CONNECT NO. 2 PARKING BRAKE CABLE ASSEMBLY
15. CONNECT REAR AXLE BREATHER HOSE SUB-ASSEMBLY
16. FILL RESERVOIR WITH BRAKE FLUID
17. BLEED BRAKE LINE
18. CHECK BRAKE FLUID LEVEL IN RESERVOIR
19. INSPECT FOR BRAKE FLUID LEAK
|
|