| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Suspension | Section: Rear Suspension | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000003BZF003X |
| Title: REAR SUSPENSION: REAR LOWER ARM: INSTALLATION (2008 LX570) | ||
INSTALLATION
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
-
A bolt without a torque specification is shown in the standard bolt chart
.
1. TEMPORARILY INSTALL LOWER CONTROL ARM ASSEMBLY LH
|
(a) Temporarily install the lower control arm with the 2 bolts, 2 washers and 2 nuts. |
2. STABILIZE SUSPENSION
3. TIGHTEN LOWER CONTROL ARM ASSEMBLY LH
(a) Tighten the 2 nuts.
Torque: 150 N·m (1530 kgf·cm, 111 ft·lbf)
NOTICE:
Perform this procedure with all 4 wheels on the ground.
|
|