| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Vehicle Exterior | Section: Wiper/Washer | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000003CEW002X |
| Title: WIPER / WASHER: RAIN SENSOR: INSTALLATION (2008 LX570) | ||
INSTALLATION
1. INSTALL RAIN SENSOR TAPE
HINT:
Only perform this procedure when replacing the rain sensor tape.
|
(a) Apply new rain sensor tape to the rain sensor surface indicated by the hatched area. NOTICE:
Standard:
|
2. INSTALL RAIN SENSOR
NOTICE:
- Make sure the adhesive between the bracket and windshield glass is normal.
- If there is any residue left from the rain sensor tape on the windshield, remove it.
- Clean the glass surface with cloth or similar material.
- Make sure there are no air bubbles between the rain sensor and windshield.
|
(a) Securely attach the rain sensor to the bracket. |
(b) Push in the stopper.
NOTICE:
The stopper can be used a maximum of 5 times.
(c) Connect the connector.
3. INSTALL RAIN SENSOR COVER
|
(a) Push in the stopper in the direction of the arrow labeled (1) to install the rain sensor cover. |
(b) Slide the No. 2 cover in the direction of the arrow labeled (2) to fix it in place.
|
|