| Last Modified: 11-27-2007 | 1.6 N | |
| Service Category: Vehicle Interior | Section: Seat | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000003DFS002X |
| Title: SEAT: REAR NO. 2 SEAT ASSEMBLY (w/ Automatic Folding-up Function): DISPOSAL (2008 LX570) | ||
DISPOSAL
HINT:
- Use the same procedures for the LH side and RH side
- The procedures listed below are for the LH side.
1. DISPOSE OF NO. 2 SEAT STAY SUB-ASSEMBLY
(a) Horizontally fix the seat stay in a vise with the piston rod pulled out.
(b) Wear safety glasses. Gradually cut an area between A and B shown in the illustration using a metal saw and gradually release the gas.
Standard:
|
Area |
Specified Condition |
|---|---|
|
a |
80 mm (3.15 in.) |
|
b |
10 mm (0.394 in.) |
CAUTION:
As metal debris may be blown outward by the gas, you must:
- Wear protective glasses.
- Cover the area being cut.
NOTICE:
The gas inside the seat stay is colorless, odorless and harmless. There is a possibility that metal debris could scatter, so cover the part with a piece of cloth or other material.
|
|