| Last Modified: 11-27-2007 | 1.6 U | |
| Service Category: Vehicle Exterior | Section: Door/Hatch | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000003EUJ000X |
| Title: DOOR / HATCH: TAIL GATE CLOSER SYSTEM: DATA LIST / ACTIVE TEST (2008 LX570) | ||
DATA LIST / ACTIVE TEST
1. DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Body No. 4 / Data List.
(e) According to the display on the Techstream, read the Data List.
Body No. 4
|
Tester Display |
Measurement Item/Range |
Normal Condition |
Diagnostic Note |
|---|---|---|---|
|
Handle Switch of tail gate panel |
Back door remote control signal/ON or OFF |
ON: Back door remote control pulled ON: Back door remote control free |
- |
|
Half Latch Switch RH |
Half-latch switch RH signal/ON or OFF |
ON: Lower tail gate open OFF: Lower tail gate closed |
- |
|
Half Latch Switch LH |
Half-latch switch LH signal/ON or OFF |
ON: Lower tail gate open OFF: Lower tail gate closed |
- |
|
Courtesy Switch RH |
Lower tail gate courtesy switch RH signal/ON or OFF |
ON: Lower tail gate open OFF: Lower tail gate closed |
- |
|
Courtesy Switch LH |
Lower tail gate courtesy switch LH signal/ON or OFF |
ON: Lower tail gate open OFF: Lower tail gate closed |
- |
|
Position Switch RH |
Close position switch RH signal/ON or OFF |
ON: Lower tail gate closed OFF: Lower tail gate open |
- |
|
Position Switch LH |
Close position switch LH signal/ON or OFF |
ON: Lower tail gate closed OFF: Lower tail gate open |
- |
|
Luggage Pawl Switch |
Pawl switch signal/ON or OFF |
ON: Lower tail gate lock motor operating OFF: Lower tail gate open or close |
- |
|
Fail Count RH |
Number of malfunctions detected in lower tail gate lock RH/0 to 5 |
Number of detected malfunctions displayed |
- |
|
Fail Count LH |
Number of malfunctions detected in lower tail gate lock LH/0 to 5 |
Number of detected malfunctions displayed |
- |
|
# Codes |
Number of stored trouble codes/min.: 0, max.: 255 |
Number of DTCs displayed |
- |
2. ACTIVE TEST
HINT:
Using the Techstream to perform the Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Body No. 4 / Active Test.
(e) According to the display on the Techstream, perform the Active Test.
Body No. 4
|
Tester Display |
Test Part |
Control Range |
Diagnostic Note |
|---|---|---|---|
|
Tail Gate Panel Open |
Lower tail gate lock |
ON or OFF |
The back door must be open. |
|
|