| Last Modified: 11-27-2007 | 1.6 C | |
| Service Category: Engine/Hybrid System | Section: Cruise Control | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000003FER000X |
| Title: CRUISE CONTROL: DYNAMIC RADAR CRUISE CONTROL SYSTEM: DESCRIPTION (2008 LX570) | ||
|
DTC |
P1572 |
Improper Aiming of Radar Sensor Beam Axis |
DESCRIPTION
This DTC is stored when there is a problem with the millimeter wave radar sensor beam axis adjustment.
|
DTC Code |
DTC Detection Condition |
Trouble Area |
|---|---|---|
|
P1572 |
The vehicle speed is 40 km/h (25 mph) or more with the cruise control main switch on (vehicle-to-vehicle distance control mode) and the millimeter wave radar sensor beam axis is misaligned (0.15 sec. or more). |
Millimeter wave radar sensor |
HINT:
If the beam axis deviates vertically by +/-2° or more and/or horizontally by +/-4° or more at a distance of 4.0 to 6.0 m (13 to 20 ft), this DTC is stored.
INSPECTION PROCEDURE
NOTICE:
When the millimeter wave radar sensor is replaced with a new one, adjustment of the radar sensor beam axis must be performed
.
PROCEDURE
|
1. |
ADJUST MILLIMETER WAVE RADAR SENSOR |
(a) Refer to the adjustment
.
HINT:
It is necessary to make the ECM recognize specification information (whether the vehicle is equipped with the dynamic radar or not). If this procedure has not been carried out, this DTC may be output.
|
|
2. |
CHECK DTC (DYNAMIC RADAR CRUISE CONTROL SYSTEM) |
(a) Using the Techstream, enter the following menus: Powertrain / Radar Cruise / Trouble Code.
(b) Clear the DTCs
.
(c) Perform the following to make sure the DTC detection conditions are met.
HINT:
If the detection conditions are not met, the system cannot detect the malfunction.
(1) Drive the vehicle at a speed of 40 km/h (25 mph) or more.
(2) Turn the cruise control main switch on to set the vehicle-to-vehicle distance control mode to the standby state.
(d) Check for DTCs
.
OK:
DTC P1572 is not output.
|
|
|