Home Vehicle Interior Seat REAR NO. 2 SEAT ASSEMBLY (w/ Automatic Folding-up Function)
Last Modified: 11-27-2007 1.6 F
Service Category: Vehicle Interior Section: Seat
Model Year: 2008 Model: LX570 Doc ID: RM000003HA0000X
Title: SEAT: REAR NO. 2 SEAT ASSEMBLY (w/ Automatic Folding-up Function): MANUAL OPEN OPERATION (2008 LX570)

MANUAL OPEN OPERATION

HINT:

  • Use the same procedures for the LH side and RH side.
  • The procedures listed below are for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE REAR SEAT CUSHION HINGE COVER LH

(a) Remove the rear seat cushion hinge cover LH SEAT: REAR NO. 2 SEAT ASSEMBLY (w/ Automatic Folding-up Function): REMOVAL (2008 LX570)+ .

3. REMOVE REAR NO. 2 SEAT HINGE COVER LH

(a) Remove the rear No. 2 seat hinge cover LH SEAT: REAR NO. 2 SEAT ASSEMBLY (w/ Automatic Folding-up Function): REMOVAL (2008 LX570)+ .

4. REMOVE RECLINING ADJUSTER COVER RH

(a) Remove the reclining adjuster cover RH SEAT: REAR NO. 2 SEAT ASSEMBLY (w/ Automatic Folding-up Function): DISASSEMBLY (2008 LX570)+ .


5. OPEN BOTTOM OF SEATBACK COVER

(a) Detach the hook.


6. REMOVE REAR SEATBACK LOCK STRIKER ASSEMBLY LH

(a) Detach the clamp.

(b) Remove the nut, bolt and remove the striker.

7. REMOVE POWER SEAT MOTOR SUB-ASSEMBLY

(a) Remove the power seat motor sub-assembly SEAT: REAR NO. 2 SEAT ASSEMBLY (w/ Automatic Folding-up Function): DISASSEMBLY (2008 LX570)+ .

8. REMOVE REAR NO. 2 SEAT ASSEMBLY

(a) Remove the rear No. 2 seat SEAT: REAR NO. 2 SEAT ASSEMBLY (w/ Automatic Folding-up Function): REMOVAL (2008 LX570)+ .

9. REMOVE REAR STEP COVER

10. REMOVE REAR DOOR SCUFF PLATE LH

11. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE

12. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

13. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH

14. REMOVE REAR ROOF NO. 1 AIR DUCT

15. REMOVE NO. 1 WOOFER BOX SPEAKER ASSEMBLY (for RH Side, w/ Woofer)


16. UNLOCK FOLD SEAT LEG LOCK SUB-ASSEMBLY BY HAND

(a) Pull the release lever in the direction shown in the illustration to release the lock.