DUST COVER > INSTALLATION

1. INSTALL DUST COVER

2. INSTALL DIFFERENTIAL SIDE GEAR SHAFT SUB-ASSEMBLY

3. INSTALL REAR DRIVE SHAFT ASSEMBLY

4. TEMPORARILY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.2

5. TEMPORARILY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.1

6. TEMPORARILY TIGHTEN REAR STRUT ROD ASSEMBLY

7. STABILIZE SUSPENSION

8. FULLY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.2

9. FULLY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.1

10. FULLY TIGHTEN REAR STRUT ROD ASSEMBLY

11. INSTALL HEIGHT CONTROL SENSOR

12. INSTALL REAR AXLE SHAFT NUT

13. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

14. INSTALL EXHAUST PIPE ASSEMBLY (for RH Side)

15. INSTALL REAR WHEEL

16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (for RH Side)

17. ADD AND INSPECT HYBRID TRANSAXLE FLUID

18. HEADLIGHT AIM ONLY (for RH Side)

19. PERFORM INITIALIZATION (for RH Side)