HYBRID TRANSAXLE SIDE GEAR OIL SEAL > INSTALLATION

1. INSTALL REAR TRANSAXLE SIDE GEAR OIL SEAL

2. INSTALL DIFFERENTIAL SIDE GEAR SHAFT SUB-ASSEMBLY

3. INSTALL REAR DRIVE SHAFT ASSEMBLY

4. TEMPORARILY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.2

5. TEMPORARILY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.1

6. TEMPORARILY TIGHTEN REAR STRUT ROD ASSEMBLY

7. STABILIZE SUSPENSION

8. FULLY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.2

9. FULLY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.1

10. FULLY TIGHTEN REAR STRUT ROD ASSEMBLY

11. INSTALL REAR AXLE SHAFT NUT

12. INSTALL HEIGHT CONTROL SENSOR

13. INSTALL EXHAUST PIPE ASSEMBLY (for RH Side)

14. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

15. INSTALL REAR WHEEL

16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (for RH Side)

17. ADD AND INSPECT HYBRID TRANSAXLE FLUID

18. HEADLIGHT AIM ONLY (for RH Side)

19. PERFORM INITIALIZATION (for RH Side)