REAR TRACTION MOTOR > REMOVAL

1. PRECAUTION

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

3. REMOVE SERVICE PLUG GRIP

4. REMOVE ENGINE ROOM SIDE COVER LH

5. REMOVE INVERTER BRACKET NO.5

6. REMOVE POWER STEERING ECU ASSEMBLY

7. SEPARATE INVERTER RESERVE TANK SUB-ASSEMBLY

8. REMOVE POWER STEERING ECU BRACKET

9. REMOVE INVERTER COVER

10. VERIFY THAT VOLTAGE OF W/ CONVERTER INVERTER ASSEMBLY IS 0V

11. INSTALL INVERTER COVER

12. DRAIN HYBRID TRANSAXLE FLUID

13. REMOVE REAR WHEELS

14. REMOVE EXHAUST PIPE ASSEMBLY

15. REMOVE REAR AXLE SHAFT LH NUT

16. REMOVE REAR AXLE SHAFT RH NUT

17. DISCONNECT HEIGHT CONTROL SENSOR

18. SEPARATE REAR STRUT ROD ASSEMBLY

19. SEPARATE REAR SUSPENSION ARM ASSEMBLY NO.1 LH

20. SEPARATE REAR SUSPENSION ARM ASSEMBLY NO.1 RH

21. SEPARATE REAR SUSPENSION ARM ASSEMBLY NO.2 LH

22. SEPARATE REAR SUSPENSION ARM ASSEMBLY NO.2 RH

23. REMOVE REAR DRIVE SHAFT ASSEMBLY LH

24. REMOVE REAR DRIVE SHAFT ASSEMBLY RH

25. SEPARATE PARKING BRAKE CABLE ASSEMBLY NO.3

26. SEPARATE PARKING BRAKE CABLE ASSEMBLY NO.2

27. SEPARATE NO.3 WIRE FRAME

28. REMOVE REAR SUSPENSION MEMBER SUB-ASSEMBLY

29. REMOVE REAR TRACTION W/ TRANSAXLE MOTOR ASSEMBLY

30. REMOVE FRONT DIFFERENTIAL SUPPORT ASSEMBLY

31. REMOVE EXTENSION WIRE ASSEMBLY