DIFFERENTIAL SIDE GEAR SHAFT > INSTALLATION

1. INSTALL DIFFERENTIAL SIDE GEAR SHAFT SUB-ASSEMBLY

2. INSTALL REAR DRIVE SHAFT ASSEMBLY

3. TEMPORARILY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.2

4. TEMPORARILY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.1

5. TEMPORARILY TIGHTEN REAR STRUT ROD ASSEMBLY

6. STABILIZE SUSPENSION

7. FULLY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.2

8. FULLY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.1

9. FULLY TIGHTEN REAR STRUT ROD ASSEMBLY

10. INSTALL HEIGHT CONTROL SENSOR

11. INSTALL REAR AXLE SHAFT NUT

12. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

13. INSTALL EXHAUST PIPE ASSEMBLY (for RH Side)

14. INSTALL REAR WHEEL

15. ADD AND INSPECT HYBRID TRANSAXLE FLUID

16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (for RH Side)

17. HEADLIGHT AIM ONLY (for RH Side)

18. PERFORM INITIALIZATION (for RH Side)