INVERTER WITH CONVERTER > INSTALLATION

1. INSTALL W/CONVERTER INVERTER ASSEMBLY

2. INSTALL INVERTER BRACKET NO.4

3. INSTALL ENGINE ROOM RELAY BLOCK ASSEMBLY

4. REMOVE INVERTER COVER

5. CONNECT NO.3 WIRE FRAME

6. CONNECT MG ECU CONNECTOR

7. CONNECT HIGH VOLTAGE CABLE OF FRONT MOTOR

8. CONNECT ENGINE WIRE NO.4

9. CHECK HIGH VOLTAGE CABLE CONNECTION

10. INSTALL INVERTER COVER

11. INSTALL POWER STEERING ECU BRACKET

12. CONNECT WATER HOSE

13. INSTALL INVERTER RESERVE TANK SUB-ASSEMBLY

14. CONNECT ENGINE ROOM WIRE NO.2

15. CONNECT CIRCUIT BREAKER SENSOR NO.1

16. INSTALL POWER STEERING ECU ASSEMBLY

17. INSTALL INVERTER BRACKET NO.5

18. INSTALL AIR CLEANER W/RESONATOR

19. INSTALL AIR CLEANER CAP W/INLET

20. INSTALL COOL AIR INTAKE DUCT SEAL

21. INSTALL COWL TOP PANEL SUB-ASSEMBLY OUTER

22. INSTALL WINDSHIELD WIPER LINK ASSEMBLY

23. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

24. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH

25. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH

26. INSTALL SERVICE PLUG GRIP

27. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

28. ADD HYBRID VEHICLE COOLANT

29. CHECK HYBRID VEHICLE COOLANT LEAKS

30. INSTALL ENGINE ROOM COVER SIDE

31. INSTALL ENGINE ROOM SIDE LH COVER

32. PERFORM INITIALIZATION