INVERTER WITH CONVERTER > REMOVAL

1. PRECAUTION

2. REMOVE ENGINE ROOM SIDE LH COVER

3. REMOVE ENGINE ROOM COVER SIDE

4. DRAIN HYBRID VEHICLE COOLANT

5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

6. REMOVE SERVICE PLUG GRIP

7. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH

8. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH

9. REMOVE REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

10. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

11. REMOVE REMOVE COWL TOP PANEL SUB-ASSEMBLY OUTER

12. REMOVE COOL AIR INTAKE DUCT SEAL

13. REMOVE AIR CLEANER CAP W/INLET

14. REMOVE AIR CLEANER W/RESONATOR

15. REMOVE INVERTER BRACKET NO.5

16. REMOVE POWER STEERING ECU ASSEMBLY

17. DISCONNECT CIRCUIT BREAKER SENSOR NO.1

18. DISCONNECT ENGINE ROOM WIRE NO.2

19. REMOVE INVERTER RESERVE TANK SUB-ASSEMBLY

20. DISCONNECT WATER HOSE

21. DISCONNECT POWER STEERING ECU BRACKET

22. REMOVE INVERTER COVER

23. VERIFY THAT VOLTAGE OF W/CONVERTER INVERTER ASSEMBLY IS 0V

24. SEPARATE ENGINE WIRE NO.4

25. DISCONNECT HIGH VOLTAGE CABLE OF FRONT MOTOR

26. DISCONNECT MG ECU CONNECTOR

27. DISCONNECT NO.3 WIRE FRAME

28. INSTALL INVERTER COVER

29. SEPARATE ENGINE ROOM RELAY BLOCK ASSEMBLY

30. REMOVE INVERTER BRACKET NO.4

31. REMOVE W/CONVERTER INVERTER ASSEMBLY