KNOCK SENSOR > INSTALLATION

1. INSTALL KNOCK CONTROL SENSOR

2. INSTALL WATER OUTLET

3. INSTALL INTAKE MANIFOLD

4. CONNECT RADIATOR HOSE INLET

5. CONNECT HEATER WATER INLET HOSE

6. CONNECT FUEL PIPE SUB-ASSEMBLY

7. INSTALL INTAKE AIR SURGE TANK

8. INSTALL EMISSION CONTROL VALVE SET

9. INSTALL ENGINE MOVING CONTROL ROD

10. INSTALL AIR CLEANER BRACKET

11. INSTALL RESERVOIR BRACKET

12. INSTALL BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY

13. INSTALL AIR CLEANER CASE W/ RESONATOR

14. INSTALL AIR CLEANER CAP W/ INLET

15. INSTALL COOL AIR INTAKE DUCT SEAL

16. ADD COOLANT

17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

18. CHECK FOR ENGINE COOLANT LEAKS

19. CHECK FOR FUEL LEAKS

20. INSTALL COWL TOP PANEL SUB-ASSEMBLY OUTER

21. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

22. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

23. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH

24. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH

25. INSTALL ENGINE ROOM COVER SIDE

26. INSTALL ENGINE ROOM SIDE LH COVER

27. PERFORM INITIALIZATION