STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic) > INSTALLATION

1. INSTALL STEERING SHAFT UNIVERSAL JOINT ASSEMBLY

2. INSTALL STEERING COLUMN HOLE COVER SUB-ASSEMBLY NO.2

3. TEMPORARILY TIGHTEN STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY

4. INSTALL STEERING COLUMN ASSEMBLY

5. INSTALL INSTRUMENT PANEL FINISH PLATE

6. CONNECT STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY

7. INSTALL AIR DUCT NO.1

8. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

9. INSTALL TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY

10. INSTALL TILT AND TELESCOPIC SWITCH

11. INSTALL STEERING COLUMN COVER

12. ADJUST SPIRAL CABLE SUB-ASSEMBLY

13. INSTALL STEERING WHEEL ASSEMBLY

14. INSPECT STEERING WHEEL CENTER POINT

15. INSTALL STEERING PAD ASSEMBLY

16. INSTALL STEERING WHEEL COVER LOWER NO.3

17. INSTALL STEERING WHEEL COVER LOWER NO.2

18. INSTALL INSTRUMENT PANEL AIRBAG ASSEMBLY LOWER NO.1

19. INSTALL INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER

20. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH

21. INSTALL FRONT DOOR SCUFF PLATE LH

22. INSTALL FRONT WHEEL LH

23. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

24. CHECK FOR DTCs (POWER TILT AND POWER TELESCOPIC STEERING COLUMN )

25. INSPECT SRS WARNING LIGHT

26. PERFORM INITIALIZATION