STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic) > REMOVAL

1. PRECAUTION

2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

4. REMOVE FRONT WHEEL LH

5. REMOVE FRONT DOOR SCUFF PLATE LH

6. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH

7. REMOVE INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER

8. REMOVE INSTRUMENT PANEL AIRBAG ASSEMBLY LOWER NO.1

9. REMOVE STEERING WHEEL COVER LOWER NO.3

10. REMOVE STEERING WHEEL COVER LOWER NO.2

11. REMOVE STEERING PAD ASSEMBLY

12. REMOVE STEERING WHEEL ASSEMBLY

13. REMOVE STEERING COLUMN COVER

14. REMOVE TILT AND TELESCOPIC SWITCH

15. REMOVE TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY

16. REMOVE AIR DUCT NO.1

17. SEPARATE STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY

18. REMOVE INSTRUMENT PANEL FINISH PLATE

19. REMOVE STEERING COLUMN ASSEMBLY

20. REMOVE STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY

21. REMOVE STEERING COLUMN HOLE COVER SUB-ASSEMBLY NO.2

22. REMOVE STEERING SHAFT UNIVERSAL JOINT ASSEMBLY