HEATER WATER PUMP > INSTALLATION

1. INSTALL HEATER WATER PUMP ASSEMBLY

2. INSTALL W/CONVERTER INVERTER ASSEMBLY

3. INSTALL INVERTER BRACKET NO.4

4. INSTALL ENGINE ROOM RELAY BLOCK ASSEMBLY

5. REMOVE INVERTER COVER

6. CONNECT NO.3 WIRE FRAME

7. CONNECT MG ECU CONNECTOR

8. CONNECT HIGH VOLTAGE CABLE OF FRONT MOTOR

9. CONNECT ENGINE WIRE NO.4

10. CHECK HIGH VOLTAGE CABLE CONNECTION

11. INSTALL INVERTER COVER

12. INSTALL POWER STEERING ECU BRACKET

13. CONNECT WATER HOSE

14. INSTALL INVERTER RESERVE TANK SUB-ASSEMBLY

15. CONNECT ENGINE ROOM WIRE NO.2

16. CONNECT CIRCUIT BREAKER SENSOR NO.1

17. INSTALL POWER STEERING ECU ASSEMBLY

18. INSTALL INVERTER BRACKET NO.5

19. INSTALL AIR CLEANER W/ RESONATOR

20. INSTALL AIR CLEANER CAP W/ INLET

21. INSTALL COOL AIR INTAKE DUCT SEAL

22. INSTALL COWL TOP PANEL SUB-ASSEMBLY OUTER

23. INSTALL WINDSHIELD WIPER MOTOR ASSEMBLY

24. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

25. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH

26. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH

27. INSTALL ENGINE ROOM COVER SIDE

28. INSTALL ENGINE ROOM SIDE LH COVER

29. INSTALL SERVICE PLUG GRIP

30. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

31. ADD HYBRID VEHICLE COOLANT

32. CHECK HYBRID VEHICLE COOLANT LEAKS

33. PERFORM INITIALIZATION