STEERING COLUMN ASSEMBLY (for Manual Tilt) > INSTALLATION

1. INSTALL STEERING SHAFT UNIVERSAL JOINT ASSEMBLY

2. INSTALL STEERING COLUMN HOLE COVER SUB-ASSEMBLY NO.2

3. TEMPORARILY TIGHTEN STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY

4. INSTALL STEERING COLUMN ASSEMBLY

5. INSTALL INSTRUMENT PANEL FINISH PLATE

6. CONNECT STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY

7. INSTALL AIR DUCT NO.1

8. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

9. INSTALL TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY

10. INSTALL STEERING COLUMN COVER

11. ADJUST SPIRAL CABLE SUB-ASSEMBLY

12. INSTALL STEERING WHEEL ASSEMBLY

13. INSPECT STEERING WHEEL CENTER POINT

14. INSTALL STEERING PAD ASSEMBLY

15. INSTALL STEERING WHEEL COVER LOWER NO.3

16. INSTALL STEERING WHEEL COVER LOWER NO.2

17. INSTALL INSTRUMENT PANEL AIRBAG ASSEMBLY LOWER NO.1

18. INSTALL INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER

19. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH

20. INSTALL FRONT DOOR SCUFF PLATE LH

21. INSTALL FRONT WHEEL LH

22. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

23. INSPECT SRS WARNING LIGHT

24. PERFORM INITIALIZATION