VALVE CLEARANCE > ADJUSTMENT

1. REMOVE ENGINE ROOM SIDE LH COVER

2. REMOVE ENGINE ROOM COVER SIDE

3. REMOVE FRONT WHEEL RH

4. REMOVE ENGINE UNDER COVER NO.1

5. SEPARATE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

6. REMOVE FRONT FENDER APRON SEAL RH

7. DRAIN COOLANT

8. DRAIN ENGINE OIL

9. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH

10. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH

11. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

12. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

13. REMOVE COWL TOP PANEL SUB-ASSEMBLY OUTER

14. REMOVE COOL AIR INTAKE DUCT SEAL

15. REMOVE AIR CLEANER CAP W/ INLET

16. REMOVE AIR CLEANER CASE W/ RESONATOR

17. REMOVE EMISSION CONTROL VALVE SET

18. REMOVE INTAKE AIR SURGE TANK

19. DISCONNECT RADIATOR HOSE INLET

20. REMOVE IGNITION COIL ASSEMBLY

21. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY

22. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY LH

23. INSPECT VALVE CLEARANCE

24. ADJUST VALVE CLEARANCE

25. INSTALL CYLINDER HEAD COVER SUB-ASSEMBLY

26. INSTALL CYLINDER HEAD COVER SUB-ASSEMBLY LH

27. INSTALL IGNITION COIL ASSEMBLY

28. CONNECT RADIATOR HOSE INLET

29. INSTALL INTAKE AIR SURGE TANK

30. INSTALL EMISSION CONTROL VALVE SET

31. INSTALL AIR CLEANER CASE W/ RESONATOR

32. INSTALL AIR CLEANER CAP W/ INLET

33. INSTALL COOL AIR INTAKE DUCT SEAL

34. INSTALL COWL TOP PANEL SUB-AEEMBLY OUTER

35. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

36. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

37. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH

38. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH

39. ADD ENGINE OIL

40. ADD COOLANT

41. CHECK FOR ENGINE COOLANT LEAKS

42. CHECK FOR ENGINE OIL LEAKS

43. INSTALL FRONT FENDER APRON SEAL RH

44. INSTALL FRONT FENDER SPLASH SHILD SUB-ASSEMBLY RH

45. INSTALL ENGINE UNDER COVER NO.1

46. INSTALL FRONT WHEEL RH

47. INSTALL ENGINE ROOM COVER SIDE

48. INSTALL ENGINE ROOM SIDE LH COVER