3MZ-FE EXHAUST PIPE > REMOVAL

for Preparation Click here



1. REMOVE ENGINE UNDER COVER NO.1


2. REMOVE ENGINE UNDER COVER NO.2


3. REMOVE OXYGEN SENSOR (for Bank1)


    A108663

  1. Disconnect the oxygen sensor connector and clamp.



    A108664E01

  1. Using SST, remove the oxygen sensor from the exhaust pipe assembly front No.3.

    SST
    09224-00010  

    NOTICE:
    Do not to damage the oxygen sensor.



4. REMOVE OXYGEN SENSOR (for Bank2)


    A108666

  1. Disconnect the oxygen sensor No.2 connector.



    A108680E01

  1. Using SST, remove the oxygen sensor No.2 from the exhaust pipe assembly front.

    SST
    09224-00010  

    NOTICE:
    Do not to damage the oxygen sensor.



5. REMOVE EXHAUST PIPE ASSEMBLY TAIL

  1. Remove the 2 bolts and 2 compression springs.

  1. Remove the exhaust pipe tail from the exhaust pipe support.



  1. Remove the gasket from the exhaust pipe center.


    A109540



6. REMOVE EXHAUST TAIL PIPE BAFFLE SUB-ASSEMBLY


    A080575E01

  1. Using a plastic hammer, tap out the exhaust tail pipe baffle uniformly to remove.



7. REMOVE EXHAUST PIPE ASSEMBLY CENTER

  1. Remove the 2 bolts and 2 compression springs.

  1. Remove the exhaust pipe center from the 3 exhaust pipe supports.

  1. Remove the gasket from the exhaust pipe front No. 3.



  1. Remove the 2 bolts and exhaust pip damper.


    A108485J01



8. REMOVE EXHAUST PIPE SUB-ASSEMBLY FRONT NO.3


  1. Remove the 2 bolts and 2 nuts, exhaust pipe front No. 3 and the 2 gaskets.


    A080577



9. REMOVE EXHAUST PIPE ASSEMBLY FRONT


  1. Remove the 2 nuts, exhaust pipe assembly front, and gasket.


    A108486