NAVIGATION SYSTEM > Vehicle Position Mark is not Updated

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK MAP DISC


    I100152E12

  1. Check that the map disc is not deformed or cracked.

    OK:
    No deformations or cracks on map disc.



NG
REPLACE MAP DISC
OK


2.CHECK MAP DISPLAY

  1. Check if a touch scroll can be performed on the map display.

    OK:
    Touch scroll can be performed.



NG
RETURN TO THE ORIGINAL INSPECTION FLOW BECAUSE THE CHECK RESULT IS NORMAL
OK


3.CHECK VEHICLE SENSOR (NAVIGATION CHECK MODE)


    I100048E11

  1. Enter the "Navigation Check" mode (Vehicle Sensors) (Click here).

  1. While driving the vehicle, compare the "Speed" indicator to the reading on the speedometer. Check if these readings are almost equal.

    OK:
    The readings are almost equal.



NG
GO TO "SPEED SIGNAL CIRCUIT BETWEEN NAVIGATION ECU AND COMBINATION METER" IN FLOW CHART
OK

RETURN TO THE ORIGINAL INSPECTION FLOW BECAUSE THE CHECK RESULT IS NORMAL