NAVIGATION SYSTEM > Vehicle Position Mark Deviates Greatly

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK GPS MARK
I100195E02

  1. Check that the GPS mark is displayed.

    OK:
    GPS mark is displayed.



NG
GO TO "GPS MARK IS NOT DISPLAYED" IN FLOW CHART
OK


2.CHECK VEHICLE SENSOR (NAVIGATION CHECK MODE)
I100048E11

  1. Enter the "Navigation Check" mode (Vehicle Sensors) (Click here).

  1. While driving the vehicle, compare the "Speed" indicator to the reading on the speedometer. Check that these readings are almost equal.

    OK:
    The readings are almost equal.



NG
GO TO "SPEED SIGNAL CIRCUIT BETWEEN NAVIGATION ECU AND COMBINATION METER" IN FLOW CHART
OK


3.CHECK VEHICLE SENSOR (NAVIGATION CHECK MODE)
I100048E09

  1. Check that the display changes between ON and OFF according to the shift lever operation (P and R).

    OK:
    Shift Lever Position
    		Display
    P
    		OFF
    R
    		ON

    HINT:
    The display is updated once per second. It is normal for the display to lag behind the actual switch operation.



NG
GO TO "REVERSE SIGNAL CIRCUIT" IN FLOW CHART
OK

RETURN TO THE ORIGINAL INSPECTION FLOW BECAUSE THE CHECK RESULT IS NORMAL