REAR AXLE CARRIER > REMOVAL

for Preparation Click here



1. REMOVE REAR WHEEL


2. SEPARATE REAR SPEED SENSOR


    C108209

  1. Remove the bolt and separate the speed sensor from the axle carrier.

    NOTICE:
    1. Be careful not to damage the speed sensor.
    2. Prevent foreign matter from adhering to the speed sensor.



3. REMOVE REAR AXLE SHAFT NUT


    C108170E01

  1. Using SST and a hammer, release the staked part of the axle shaft nut.

    SST
    09930-00010  

    NOTICE:
    Loosen the staked part of the nut completely, otherwise the screw of the drive shaft may be damaged.

  1. While applying the brakes, remove the axle shaft nut.



4. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY


    C108172

  1. Remove the 2 bolts and separate rear disc brake caliper assembly.

    NOTICE:
    Use a string or other device to keep the brake caliper from hanging down.



5. REMOVE REAR DISC


    F045499E01

  1. Put matchmarks on the rear disc and the axle hub.



    D028126

  1. Release the parking brake, and remove the rear disc.

    HINT:
    If the disc cannot be removed easily, turn and press firmly the shoe adjuster until the wheel comes free.



6. SEPARATE PARKING BRAKE CABLE ASSEMBLY NO.3


    C107671J01

  1. Remove the nut, and separate the parking brake cable No.3.



7. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY


    C108173

  1. Remove the 4 bolts and the rear axle hub and bearing assembly.



8. REMOVE REAR STRUT ROD ASSEMBLY

  1. Support the rear axle carrier with a wooden block placed between the jack and axle carrier.



    C108174

  1. Remove the 2 bolts, 2 nuts and strut rod assembly rear.



9. SEPARATE REAR SUSPENSION ARM ASSEMBLY NO.1


    C108206

  1. Remove the bolt and nut, and separate the rear suspension arm assembly No.1.



10. SEPARATE REAR SUSPENSION ARM ASSEMBLY NO.2


    C108207

  1. Remove the bolt and nut, and separate the rear suspension arm assembly No.2.



11. REMOVE REAR AXLE CARRIER SUB-ASSEMBLY


    C108208

  1. Remove the 2 bolts and 2 nuts, and the rear axle carrier sub-assembly from the shock absorber.

    NOTICE:
    1. Be careful not to damage the outboard joint boot.
    2. Be careful not to damage the speed sensor rotor.