FRONT PASSENGER AIRBAG ASSEMBLY > REMOVAL

for Preparation Click here



1. PRECAUTION

CAUTION:
Be sure to read "PRECAUTION" thoroughly before servicing (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.



3. REMOVE FRONT DOOR SCUFF RH PLATE

HINT:
Use the same procedures for the front door scuff RH plate and the front door scuff LH plate (Click here).



4. REMOVE FRONT DOOR OPENING TRIM RH WEATHERSTRIP


5. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:
Use the same procedures for the cowl side trim sub-assembly RH and the cowl side trim sub-assembly LH (Click here).



6. REMOVE INSTRUMENT PANEL NO.2 UNDER COVER SUB-ASSEMBLY


    B108512E02

  1. Using a screwdriver, push the 3 claws in the direction indicated by the arrow to disengage and remove the guide on the front of the vehicle.

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the connectors and remove the instrument panel No.2 under cover sub-assembly.



7. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY


    B108513E02

  1. Remove the 2 bolts <A> and the 2 screws <C>.

  1. Pull the glove compartment door assembly to the rear to remove it.

  1. Disconnect the connector.



8. DISCONNECT FRONT PASSENGER AIRBAG ASSEMBLY CONNECTOR


    C111073

  1. Disconnect the 2 connectors from the front passenger airbag assembly.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



9. REMOVE INSTRUMENT PANEL ASSEMBLY

HINT:
Refer to the procedures up to "REMOVE INSTRUMENT PANEL ASSEMBLY" (Click here).



10. REMOVE INSTRUMENT PANEL BRACKET SUB-ASSEMBLY CENTER


    B108530

  1. Remove the screw <C> and the instrument panel bracket sub-assembly center.



11. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY


    H042744E01

  1. Remove the 2 screws.



    H042745E01

  1. Release the rear side airbag door from the hook by slightly deflecting it and roll the front passenger airbag assembly forward.

  1. Release the front side airbag door from the other hook and remove the front passenger airbag assembly.