CURTAIN SHIELD AIRBAG ASSEMBLY > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH


  1. Install the curtain shield airbag assembly LH with the 9 bolts in the order shown in the illustration.

    Torque:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }



    H042752E02

    NOTICE:
    Do not twist the curtain shield airbag assembly LH when installing it.

  1. Connect the connector to the curtain shield airbag assembly LH.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



2. INSTALL ROOF HEADLINING ASSEMBLY

HINT:
Refer to the procedures from "INSTALL ROOF HEADLINING ASSEMBLY" (Click here).



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


4. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    HINT:
    Some systems need initialization when disconnecting the cable from the negative battery terminal.



5. INSPECT SRS WARNING LIGHT

  1. Inspect the SRS warning light (Click here).