CURTAIN SHIELD AIRBAG ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. PRECAUTION

CAUTION:
Be sure to read "PRECAUTION" thoroughly before servicing (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.



3. REMOVE ROOF HEADLINING ASSEMBLY

HINT:
Refer to the procedures up to "REMOVE ROOF HEADLINING ASSEMBLY" (Click here).



4. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH

  1. Disconnect the connector from the curtain shield airbag assembly LH.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



  1. Remove the 9 bolts and the curtain shield airbag assembly LH in the order shown in the illustration.


    H042752E01