CURTAIN SHIELD AIRBAG ASSEMBLY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT CURTAIN SHIELD AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)

  1. Perform a diagnostic system check (Click here).



    H042874E01

  1. With the curtain shield airbag assembly installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the front pillar garnish or roof headlining assembly with a new one:

    1. Cuts, minute cracks or marked discoloration on the front pillar garnish or roof headlining assembly around the curtain shield airbag assembly.



2. INSPECT CURTAIN SHIELD AIRBAG ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)

  1. Perform a diagnostic system check (Click here).



    H042867E02

  1. With the curtain shield airbag assembly removed from the vehicle, perform a visual check. If there are any defects as mentioned below, replace the curtain shield airbag assembly with a new one:

    1. Cuts, minute cracks or marked discoloration on the curtain shield airbag assembly.
    2. Cracks or other damage to the connector.

    CAUTION:
    Be sure to follow the correct removal and installation procedures.