WATER PUMP WITH MOTOR > REMOVAL

for Preparation Click here



1. REMOVE ENGINE ROOM SIDE LH COVER


    A108719

  1. Using a clip remover, remove the engine room side cover.



2. DRAIN HYBRID VEHICLE COOLANT

  1. Remove the transaxle side reserve tank.

    NOTICE:
    Do not remove the reserve tank cap when the engine is hot.



    C110953

  1. Loosen the bleeder plug shown in the illustration and drain the coolant.

  1. Close the bleeder plug.



    C109300

  1. Remove the plug and gasket shown in the illustration and drain the coolant.

  1. Install the plug with a new gasket.

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }



3. REMOVE ENGINE UNDER COVER NO.1


    A108722

  1. Remove the 6 bolts, 2 screws, 2 clips and engine under cover.



4. REMOVE OIL NO.1 COOLER ASSEMBLY

  1. Disconnect the 2 oil cooler hoses.



    C113112

  1. Remove the 3 bolts, and oil cooler assembly.



    C113874

  1. Remove the 3 bolts and air duct.



5. REMOVE FRAME SIDE RAIL PLATE SUB-ASSEMBLY


    A108529

  1. Using a transmission jack, hold the front frame.

    NOTICE:
    Be sure to position the transmission jack to properly support the front frame.

  1. Remove the 3 bolts, nut and frame side rail plate sub-assembly.



6. REMOVE WATER W/ MOTOR AND BRACKET PUMP ASSEMBLY

  1. Disconnect the connector and 2 water hoses from the water w/ motor and bracket pump assembly.



    A116492

  1. Remove the bolt, nut and water w/ motor and bracket pump assembly.