HYBRID VEHICLE CONTROL ECU > INSTALLATION

for Preparation Click here



1. INSTALL WIRE HARNESS CLAMP BRACKET

  1. Install the wire harness clamp bracket with the 2 screws.



2. INSTALL ECM BRACKET NO.2

  1. Install the ECM bracket No.2 with the 2 screws.



3. INSTALL ECM BRACKET NO.1

  1. Install the ECM bracket No.1 with the 2 screws.



4. INSTALL HYBRID VEHICLE CONTROL ECU

  1. Install the hybrid vehicle control ECU with the 2 nuts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Connect the 6 connectors to the hybrid vehicle control ECU.

  1. Connect the 3 wire harness clamps.



5. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY


    B108513E03

  1. Connect the connectors.

  1. Install the 2 bolts <A>, the 2 screws <C>, and the glove compartment door assembly.



6. INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO.2


    B112171

  1. Connect the connectors.

  1. Engage the 3 claws and install the instrument panel No.2 under cover sub-assembly.



7. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH


8. INSTALL FRONT DOOR SCUFF PLATE RH


9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


10. PERFORM INITIALIZATION
Some systems need initialization when reconnecting the battery cable. (Click here)