CAN COMMUNICATION SYSTEM (for RHD) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


NOTICE:
  1. Refer to troubleshooting of each system if DTCs regarding the CAN communication system are not output.
  2. DTCs U0110-159, U0110-160, U0110-656, and U0110-657 are not DTCs for the CAN communication system. Therefore, refer to the troubleshooting procedures for the hybrid control system.



1.CHECK AND CLEAR DTCS

    NEXT


    2.CHECK FOR INSTALLED SYSTEMS (ECUS & SENSORS) THAT ADOPT CAN COMMUNICATION)

    1. Check if the parking assist monitor system is installed.


    NEXT


    3.CHECK CAN BUS LINE

    1. Check CAN bus line (Click here).


    NEXT


    4.CHECK INTELLIGENT TESTER

    1. Select "Communication Bus Check" (Click here).

      Result:

      Symptom
      		Proceed to
      All the ECUs and sensors connected to the CAN communication system are displayed on the screen.
      		A
      An ECU or sensor not connected to the CAN communication system is displayed on the screen.
      		B
      More than one of the ECUs and sensors not connected to the CAN communication system are displayed on the screen. (If the displayed ECUs and sensors are only those relating to the 'ENGINE' and 'HV', proceed to B)
      		C

      NOTICE:
      1. The systems (ECUs, sensors) that adopt CAN communication vary depending on the vehicle and option settings. Check which systems (ECUs, sensors) are installed on the vehicle (Click here).
      2. Non-installed ECUs or sensors are not displayed. Do not mistake them for being in the communication stop mode.
      3. If 2 or more ECUs or sensors are not displayed on the intelligent tester, perform troubleshooting for communication stop mode for each undisplayed ECU or sensor. (Open in one side of the CAN sub bus lines.)
      4. If DTCs U0146-435 and P3108-594 are output and 'GATEWAY' is displayed in 'Communication Bus Check' on the intelligent tester, refer to the MULTIPLEX COMMUNICATION SYSTEM.



    		B.
    GO TO "COMMUNICATION STOP MODE TABLE"

    		C.
    GO TO "CHECK FOR AN OPEN IN ONE SIDE OF THE CAN SUB BUS LINES"
    A


    5.DTC COMBINATION TABLE

    1. Confirm trouble according to the combination of output DTCs regarding the CAN communication system.

      HINT:
      Previous CAN communication system DTCs may be the cause if CAN communication system DTCs are output and all ECUs and sensors connected to the CAN communication system are displayed on the intelligent tester's "Communication Bus Check" screen.


    NEXT


    6.CIRCUIT INSPECTION

      NEXT


      7.IDENTIFICATION OF PROBLEM

        NEXT


        8.REPAIR OR REPLACE

          NEXT


          9.CONFIRMATION TEST

            NEXT

            END