CAN COMMUNICATION SYSTEM (for LHD) > Steering Sensor Communication Stop Mode

for Preparation Click here


DESCRIPTION


Detection Item
Symptom
Suspected Area
STEERING SENSOR COMMUNICATION STOP MODE
  1. "Steering sensor" is not displayed on the "Communication Bus Check" screen of the intelligent tester
  2. Applies to "STEERING SENSOR COMMUNICATION STOP MODE" in the "DTC COMBINATION TABLE"
  1. Power source circuit of the steering sensor
  2. Steering sensor

WIRING DIAGRAM


C113737E05


INSPECTION PROCEDURE

1.CHECK WIRE HARNESS (IG, ESS)

  1. Turn the ignition switch off.



    G030155E21

  1. Disconnect the steering sensor connector (S10).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Condition
    		Specified Value
    S10-2 (ESS) - Body ground
    		Always
    		Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    		Condition
    		Specified Value
    S10-1 (IG1) - Body ground
    		Ignition switch on
    		10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE STEERING SENSOR