FRONT CIRCUIT BREAKER SENSOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM BATTERY NEGATIVE TERMINAL


2. REMOVE ENGINE ROOM SIDE LH COVER


    A108719

  1. Using a clip remover, remove the engine room side cover.



3. REMOVE AIR CLEANER CAP W/INLET


    A108124

  1. Remove the 2 bolts, 4 clamps and air cleaner cap w/ inlet.

  1. Remove the air cleaner filter element from the air cleaner case.



4. REMOVE CIRCUIT BREAKER SENSOR NO.1


    A108510E01

  1. Move the outer section to the wire harness side as illustrated, then disconnect the circuit breaker sensor No.1.



    A108507

  1. Remove the 2 bolts and circuit breaker sensor No.1 from the w/ converter inverter assembly.