REAR CIRCUIT BREAKER SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL REAR CIRCUIT BREAKER SENSOR


  1. Install the rear circuit breaker sensor (RH).



      A108508

    1. Install the circuit breaker sensor (RH) with the 2 bolts.

      Torque:
      8.0 N*m{ 82 kgf*cm , 71 in.*lbf }



      2. A109511

    2. Connect the connector to the rear circuit breaker sensor (RH).



  1. Install the rear circuit breaker sensor (LH).



      A108509

    1. Install the rear circuit breaker sensor (LH) with the 2 bolts.

      Torque:
      8.0 N*m{ 82 kgf*cm , 71 in.*lbf }



      2. A109512

    2. Connect the connector to the rear circuit breaker sensor (LH).



2. INSTALL DECK SIDE TRIM BOX RH


3. INSTALL DECK SIDE TRIM BOX LH


    B111781

  1. Install the deck side trim box with the 2 clips.



4. INSTALL DECK BOARD SUB-ASSEMBLY NO.3


    B110025

  1. Install the deck No.3 board sub-assembly with the 2 bolts and 2 nuts.



5. INSTALL DECK BOARD SUB-ASSEMBLY NO.2


    B110024

  1. Install the deck No.2 board sub-assembly with the 4 bolts and 2 nuts.



6. INSTALL DECK FLOOR BOX FRONT


    B110022

  1. Install the deck floor box front with the 2 clips.



7. INSTALL REAR FLOOR FINISH PLATE


    B110477

  1. Engage the 2 claws and 6 clips, and install the rear floor finish plate.

  1. Install the 2 clips.



8. INSTALL DECK FLOOR BOX REAR


    B110023

  1. Install the deck floor box rear with the 2 clips.



9. INSTALL DECK BOARD SUB-ASSEMBLY


    B110455

  1. Install the deck board sub-assembly with the 2 bolt.

  1. Engage the 5 clips.



10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


11. PERFORM INITIALIZATION
Some system need initialization when reconnecting the battery cable. (Click here)